Switching Hall SS400 Series

Product Introduction:
The SS400 series position sensor has a thermally balanced integrated circuit over the entire temperature range, and the negative compensation slope is optimized to match the negative temperature coefficient of the low-cost magnet. Bipolar latched magnetic elements and unipolar magnetic elements available

Key features:
1) 3.8 ~ 30Vdc power supply
2) Digital current sink output
3) 3 pin a column of PCB pins
4) Block Hall design eliminates mechanical pressure effects
5) Magnetic characteristics temperature compensation
6) Customizable special action/release points
7) Bipolar, unipolar, latch type
8) Very high output current capability --- Max absolute current 50mA
9) The moving point/release point is symmetrical to the zero Gaussian (bipolar latch)
10) Operating temperature range -40~150 degrees Celsius
11) Packaging material: Plaskon 3300H
12) Surface packaging model: SS400-S (cut short or reshaped pins)

Scope of application:
Brushless DC motor, automobile engine management system (electronic injection system), ignition timing, power measurement, valve position, robot control, current sensing, linear/selective position detection, length detection, flow measurement, RPM (revolutions per minute) measurement, safety system